Product ID:POLYURETHANE POWDER COATING, P-SERIES
MSDS Date:02/07/1996
FSC:8010
NIIN:00N072123
MSDS Number: CBXPW

CARDINAL INDUSTRIAL FINISHES

1329 POTRERO AVE
SOUTH EL MONTE, CA 91733
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 818-444-9274;213-283-9335

Preparer: ROBERT SYPOWICZ

Cage: 65860

CARDINAL INDUSTRIAL FINISHES

SOUTH EL MONTE, CA 91733 US

Telephone: 818-444-9274 OR 213-283-9335

Cage: 65860

CARBON BLACK

CAS: 1333-86-4

RTECS: FF5800000

Fraction By Weight: 0-5%

OSHA PEL 3.5 MG/M3

ACGIH TLV: 3.5 MG/M3

E-CAPROLACTAN (MFR INVALID CAS #14505-60-2)

Fraction By Weight: 0-10%

OSHA PEL N/K

ACGIH TLV: N/K

BARIUM SULFATE

CAS: 7727-43-7

RTECS: CR0600000

Fraction By Weight: 0-40%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST

SEPARATED BY PARTITION. STORE @ TEMPS BETWEEN 60 &

RTECS: 9999999ZZ

ALTHOUGH MATL IS POWDER COATING W/LOW TOX, FOLLOW

RTECS: 9999999ZZ

ENGINEERING/ADMINISTRATIVE CONTROLS SHOULD BE

RTECS: 9999999ZZ

& DELUGE SHOWER .

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE:EYES:CAN CAUSE IRRITATION AND
REDNESS, TEARING OR BLURRED VISION. SKIN:IRRITATION, RASH AND
DERMATITIS POSSIBLE FROM PROLONGED EXPOSURE. INHALATION:COUGHING,
SNEEZING, NASAL IRRITATION, HEADACHE , DIZZINESS, NAUSEA.
INGESTION:GASTROINTESTINAL IRRITATION, HEADACHE, DIZZINESS, NAUSEA,
WEAKNESS.
Explanation of Carcinogenicity:CARBON BLACK:IARC MONOGRAPHS ON EVAL OF
CARCIN RISK OF CHEMS TO MAN, VOL. 65:GROUP 2B.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY
CONDITIONS, PRE-EXISTING SKIN DISORDERS.

First Aid:EYES:FLUSH W/WATER FOR AT LEAST 15 MINUTES. GET MEDICAL
ATTENTION IMMEDIATELY. SKIN:WASH EXPOSED AREA W/SOAP & WATER.
REMOVE CONTAMD CLOTHING. INHALATION:REMOVE TO FRESH AIR. IF
BREATHING IS DIFFICULT , ADMIN OXYGEN. IF BREATHING HAS STOPPED,
GIVE ARTIFICAL RESPIRATION. GET MEDICAL ATTENTION. INGEST:INDUCE
VOMITING, KEEP PERSON WARM & QUIET. GET MEDICAL ATTENTION.

Extinguishing Media:FORM, DRY CHEMICAL, CARBON DIOXIDE, WATER FOG.
Fire Fighting Procedures:USE NIOSH APPRVD SCBA & FULL PROT EQUIP .
NOTE!PROD IS DRY POWDER & UNDER NORM OPERATING CNDTNS PRESENTS
MINIMAL RISK OF FIRE/EXPLO. HOWEVER, (SUPDAT)
Unusual Fire/Explosion Hazard:WHEN EXPOSED TO EXTREME HEAT,
DECOMPOSITIONS PRODUCTS MAY YIELD, OXIDES OF CARBON & NITROGEN OR
TOXIC FUMES.

Spill Release Procedures:REFER TO FIRE & EXPLO RISK, HLTH HAZ DATA,
REACTIVITY DATA, SPILL/LEAK PROD AND SAFE HNDLG & USE INFO
SECTIONS. ELIM ALL IGNIT SOURCES. SWEEP UP SPILLS & PLACE IN
DRUM/OTHER SEALABLE CNTNR. AVOID GENE RATING DUST FROM CLEAN UP
MATERIAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY PLACE & PROTECT
FROM BREAKAGE. AVOID STORING @ TEMPS ABOVE 80F. AVOID EXCESS
MOISTURE/HUMIDITY. KEEP CNTNRS TIGHTLY SEALED.
Other Precautions:DO NOT STORE NEAR OVENS/SOURCES OF EXTREME HEAT. DO
NOT ALLOW POWDER DUST TO ACCUM NEAR MACHINERY/SOURCES OF IGNIT.
POWDER COATINGS SHOULD BE APPLIED ONLY W/PROPER APPLIC EQUIP W/IN
PROPERLY VENTILATE D CONTROL ENCLOSURE. POWDER (SUPDAT)

Respiratory Protection:IF TLV OF PROD/ANY COMPONENT IS EXCEEDED, NIOSH
APPRVD JOINTLY APPRVD AIR SUPPLIED RESP IS ADVISED IN ABSENCE OF
ENVIR CONTROL. OSHA REGS ALSO PERMIT OTHER NIOSH APPRVD RESPS UNDER
SPECIFIED CNDTNS. ( SEE SFTY EQUIP SUPPLIER). (ING 7)
Ventilation:PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL
EXHAUST) VENT TO CONTROL DUST ACCUM & MAINTAIN EXPOS BELOW TLV(S).
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:PVNT RPTD/PRLNGD SKIN CONT W/GB PROT HAND
CREAM, WEAR IMPERVIOUS CLTHG & CHEM RESIST BOOTS. ANSI APPRVD EYE
WASH (ING 8)
Work Hygienic Practices:WASH HANDS BEFORE EATING OR USING REST ROOM,
SMOKE IN SMOKING AREAS ONLY.
Supplemental Safety and Health
FIRE FIGHT PROC:PROPER STOR, & CAUTION IN HNDLG & USE PRACTICES SHOULD
BE USED AT ALL TIMES. OTHER PREC:COATING EQUIP SHOULD BE GROUNDED @
ALL TIMES TO PVNT STATIC ELEC BUILD-UP. (OSHA 29CFR 1910.107) NO
OPEN FLAMES/SOURCES OF IGNIT/SPK PRODUCING EQUIP SHALL BE LOCATED
W/IN 20 FEET OF POWDER USE, UNLESS (ING 5)

Vapor Density:HVR/AIR
Spec Gravity:1.2-1.8
VOC Pounds/Gallon:34
Solubility in Water:NOT KNOWN
Appearance and Odor:POWDER OF VARIOUS COLORS.
Percent Volatiles by Volume:>97

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:EXTREME TEMPERATURES.
Hazardous Decomposition Products:NONE SPECIFIED BY MANUFACTURER.

Waste Disposal Methods:REUSE OR RECYCLE WHENEVER POSSIBLE, DESTROY
WASTE SOLIDS BY INCINERATION, OR DISPOSE OF IN APPROVED LANDFILL IN
ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.